IC980DHC intelligent leather cutting machine

IC980DHC 

INTELLIGENT LEATHER CUTTING MACHINE

IC980DHC is specially developed by ITTA for the automotive seat and interior industry, aiming to solve the high cost and low efficiency problems caused by the reliance on traditional manual nesting and die cutting. IC980DHC is equipped with 2 fans imported from Germany, four projectors, two cutting heads in two independent working areas, each with four tools (one cutting, two punching, one line pen). In terms of leather utilization, it is 2%-15% higher than the traditional cutting method in the automotive industry.

To better meet the production needs of the automotive seat and interior industry, IC980DHC has the following advantages:

1. The left and right working areas are 3.2 meters long and 2.8 meters wide, which is more suitable for the common automotive used leather size.

2. The left and right ends of the machine are equipped with pullable waste frames, which can not only prevent the leather from falling to the ground when laying the skin, but also facilitate the collection of waste materials and ensure a clean workshop environment.

3. The edge of the machine is narrower, which is convenient for workers to sort out the leather and ensure that the leather is flat.

4. Using a higher power servo motor, the production speed is faster, and the output of genuine leather can reach 7,500-9,000 feet in 8 hours.

5. The electric box is a pull-out design, which is more convenient for daily maintenance and repair, and minimizes the impact on the production schedule.

6.  The projection stand is equipped with a status light, and the operation status of the machine is clear at a glance, improving the operation safety.

In the field of automotive interiors, ITTA not only cooperates closely with new car-making supply chain enterprises such as NIO, Xiaopeng and Li Auto in China, but also becomes a long-term supplier of intelligent leather cutting equipment for LEAR Group's global factories.

Parameters：

Machine   dimension(LxWxH)	8680x3510x3140mm
Double   working areas(LxW)	3200x2800mmx2
Power	3-phase   200-400vac/50-60Hz，15KW Monophase200-240VAC/50-60Hz   2KW
Vibration   frequency of the knife	15000-18000 times/min
Air   consumption	0.4-0.6MPa
Tools	Each cutting headis equipped with: one cutter and two punches
Compatible leather scanner	IN400A   /IR-3000 (Nesting machine)